BMC Timemachine User Manual download pdf (Page 18)

1 Frame preparation Refer to page 14, install rear wheel adjusters

2 Mount the brake arms in frame Refer to page 15

3 Rear brake cable routing Refer to page 19

4 Shifting cable routing Non Di2: Refer to page 27

5 Shifting cable routing Di2: Refer to page 25

6 Derailleur, front and rear Refer to manufacturers instructions

7 Fork and headset Refer to page 29

8 Stem Refer to page 31

9 Handlebars Di2: Refer to page 27

10 Front brake cable routing Refer to page 18

11 Install the pipes on brake cables Refer to pages 19

12 Brake cable tension front and rear Refer to pages 21 and 22

13 Mount wheels and brake pads Refer to page 22

14 Bolt on stem cover For TM01: Refer to page 36

15 Install top tube cable guide Only for TM02

16 Seat post installation Refer to page 33

17 Crankset Mount the crank set once the rear brake is properly set

18 Chain Refer to manufacturers instructions

19 Gears Adjust the shifting, refer to manufacturers instructions

20 Bar tape Wrap the bar tape as a ﬁnal step

If you are building a timemachine frameset from scratch, the most convenient way is to follow the order and the procedure described

below. This is only the global procedure, all the seperate steps and recommendations are described one by one in the next pages of

this manual.

Please go through all the instructions before starting the assembly of the frameset.

Recommended procedure

FD cable stopper for mechanical groupset

Part N° 210995

Frame preparation

Di2 speciﬁc parts

When the frameset is built with Shimano Di2 groupset, replace the front derailleur cable stopper by the special cover

(highlighted in blue).

Cover for Di2 groupset

Part N° 210996

Building a timemachine

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 41 42

No comments

BMC Timemachine User Manual Page 18